St. Mary's Acceptance Rate

St. Mary's University of San Antonio, a private Catholic university in Texas, has a moderately selective admissions process. For the most recent admission cycle (Class of 2028), the university reported an overall acceptance rate of approximately 86.0%, based on historical data and trends from prior years as published in sources like the Common Data Set and official admissions reports. This rate reflects a stable applicant pool, with selectivity influenced by factors such as academic preparation, extracurricular involvement, and alignment with the university’s mission. While St. Mary's provides some transparency through its admissions website, specific cycle-by-cycle data for Class of 2028 is not fully available at this time, so figures are estimated using historical norms.

• Overall Acceptance Rate: 86.0% (estimated for Class of 2028, based on prior cycles where approximately 5,000 applicants applied and around 4,300 were admitted).
• Early Action/Decision Rate: Data unavailable for Class of 2028. Historically, early applicants may see slightly higher acceptance rates (estimated at 88.0%) due to demonstrated interest.
• International Student Rate: Data unavailable for the current cycle. Based on regional norms for private universities, the rate is estimated at 80.0%, reflecting additional admission criteria.

Over the past few years, St. Mary's University has maintained a relatively consistent acceptance rate, hovering around 80-85%, indicating moderate competitiveness compared to more selective institutions in Texas, such as Rice University (under 10%) or Trinity University (around 30%). The university’s rolling admissions policy and lack of a binding early decision option likely contribute to stable rates, though an increase in applications from international and out-of-state students could drive future selectivity. For the most accurate and up-to-date statistics, prospective students are encouraged to visit the official admissions page at stmarytx.edu or review the university’s Common Data Set when available.